You are here

Thin Wall/Mirco-Bore Tubing

As the medical industry continues to demand more minimally invasive device designs, the tubing used within these devices must become thinner and smaller. Fluortek can support your design with our custom thin wall and micro-bore PTFE extrusions, often used as the inner layer/liner of braid and coil reinforced catheters.

Thin Wall PTFE Extrusions

  • IDs from 0.021" (0.53mm) to 0.300" (7.62mm)
  • Walls from 0.001" (0.0254mm)
  • Available on silver-plated copper wire from 0.016" (0.41mm) to 0.087" (2.21mm)
  • Available with sodium-naphthalene-etched OD for surface bonding

Micro-Bore PTFE Extrusions

  • IDs from 0.002" (0.051mm) to 0.020" (0.51mm)
  • Walls from 0.001" (0.0254mm)
  • Available extruded over wire from 0.008" (0.20mm)
  • Available with sodium-naphthalene-etched OD for surface bonding